P. 10-03 Step 1, fabricate the tail skid bracket. Used the template provided in the kit and it worked perfectly. Figure 1 has direction of what to do and wehre to do it. I was not sure of the diagram that shows 5 inches long by 1 inch wide. That was because I was perceiving it incorrectly. It is a sideview of the tailskid showing where to make the tapered cut. I will prime the skid before installation. MCS required on the bulkhead doubler (F-1211B) for AN426AD4 and AN426AD3, so be sure to use the right bit. Again, I practice on scrap and then if possible use the drill press to finish on the part. This went well.
No comments:
Post a Comment