P.08-02 Anti-Servo Tab (AST) installation. Working 6 hours on the AST resulted in completing this task. Everything went well and if paying attention to the plans, no real challenges. Pay attention to the hinge halves so that you end up with parts that match the plans. Measure twice, cut once. Using the eyelet template to drill holes in the hinges worked well. I used the drill press to make these holes, being careful to keep the template positioned correctly. (The template would not fit into the hings for me, so using a file, I took a little material off each notch. Be careful if you do this because you can easily take too much and then the template will not hold itself in place.)
No comments:
Post a Comment